| HOME | HELP | FEEDBACK | SUBSCRIPTIONS | ARCHIVE | SEARCH | TABLE OF CONTENTS |
| ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Deptartment of Chemical and Biological Engineering, Northwestern University, Evanston, IL 60208
Correspondence: Address reprint requests to Eleftherios Terry Papoutsakis, Dept. of Chemical and Biological Engineering, Northwestern University, Evanston, IL 60208. Tel.: 847-491-7455; Fax: 847-491-3728; E-mail: e-paps{at}northwestern.edu.
Typical DNA microarrays utilize diffusion of dye-labeled cDNA probes followed by sequence-specific hybridization to immobilized targets. Here we experimentally estimated the distance typical probes travel during static 16-h hybridizations. Probes labeled with Cy3 and Cy5 were individually introduced to opposite sides of a microarray with minimal convective mixing. Oppositely labeled probes diffused across the initial front separating the two solutions, generating a zone with both dyes present. Diffusion-distance estimates for Cy3- and Cy5-labeled cDNAs were 3.8 mm and 2.6 mm, respectively, despite having almost identical molecular masses. In separate 16-h hybridization experiments with oppositely labeled probes premixed, arrays that were continuously mixed had 1520% higher signal intensities than arrays hybridized statically. However, no change was observed in the Cy3/Cy5 signal intensity ratio between continuously mixed and static hybridizations. This suggests that the observed dye bias in diffusion-distance estimates results from differences in the detection limits of Cy3 and Cy5-labeled cDNA, a potential concern for array data on low-abundance transcripts. Our conservative diffusion-distance estimates indicate that replicate targets >7.6 mm apart will not compete for scarce probes. Also, raising the microarray gap height would delay the onset of diffusion-limited hybridization by increasing the amount of available probe.
| HOME | HELP | FEEDBACK | SUBSCRIPTIONS | ARCHIVE | SEARCH | TABLE OF CONTENTS |